Remote weighing monitor for belt scales, weighbridges, and silo inventory.
Continuous silo and container level monitoring with fill and low-stock alerts.
Continuous conveyor belt scale monitoring, part of the SensWEIGHT® platform.
Which one do I need?
The three systems differ in what they measure, not in how they are run.
SensWEIGHT® Bridge
Choose this if you weigh something that moves — trucks across a weighbridge, loads leaving a pit, batches into a mixer.
It reads up to 8 load cells in real time and watches each one for drift, failure and tampering, so a failing cell is found instead of quietly costing you money for months. The diagnostic method is covered by European patent EP 4 524 526.
SensSILO
Choose this if you need to know how much is in a silo, tank or container without sending someone to dip it.
It measures the stored mass continuously and raises fill and low-stock alerts, replacing a reading taken by hand once a shift with a figure that is always current.
SensBELT
Choose this if the material travels on a conveyor and you bill, budget or reconcile from belt-scale totals.
It measures continuous gravimetric flow, with empty-belt detection and a running calibration check. SensBELT is part of the SensWEIGHT® platform rather than a separate system, so it shares the same dashboard.
The same in all three
One dashboard, one alerting model and one set of reports, whichever system you run. We engineer, install and commission the hardware ourselves, and any of the three can be tried on a free 30-day pilot — we lend you the system for a month at no cost.